Articles producció científica> Enginyeria Química

Direct liquid-liquid extraction of lipid from municipal sewage sludge for biodiesel production

  • Dades identificatives

    Identificador: imarina:6387932
    Autors:
    Olkiewicz MCaporgno MFortuny AStüber FFabregat AFont JBengoa C
    Resum:
    Municipal sludge from wastewater treatment plants is a promising lipid feedstock for biodiesel production as it contains a significant amount of lipids. However, the energy necessary to remove its high water content is a major inconvenience for scaling up because of the high associated cost. In addition, the expensive conventional sludge drying methods are not effective enough for lipid recovery, thus reducing the potential biodiesel production. This study explores an alternative method, the direct sequential liquid-liquid extraction, which was performed in a batch mixer-settler reactor at room temperature, using hexane as a solvent, after previous sludge acidification showed significant increase in the lipid efficiency. The optimisation study demonstrated that, after three stages, 91% of lipid from primary sludge was recovered. The optimised extraction gave slightly higher lipid (27%, dry sludge) than the standard method (25%, dry sludge), supporting the suitability of the proposed process. Finally, this work demonstrates that the residual lipid-extracted sludge is still a good feedstock for energy production via anaerobic digestion. Anyway, the economic and environmental aspects of biodiesel production from sewage sludge could be improved. © 2014 Elsevier B.V.
  • Altres:

    Autor segons l'article: Olkiewicz M; Caporgno M; Fortuny A; Stüber F; Fabregat A; Font J; Bengoa C
    Departament: Enginyeria Química
    Autor/s de la URV: Bengoa, Christophe José / CAPORGNO, MARTIN PABLO / Fabregat Llangostera, Azael / Fabregat Sanjuan, Albert / Font Capafons, José / Fortuny Sanromà, Agustín / OLKIEWICZ, MAGDALENA ANNA / Stüber, Frank Erich
    Paraules clau: Sewage sludge Liquid-liquid extraction Lipids Lipid Biodiesel Acidification
    Resum: Municipal sludge from wastewater treatment plants is a promising lipid feedstock for biodiesel production as it contains a significant amount of lipids. However, the energy necessary to remove its high water content is a major inconvenience for scaling up because of the high associated cost. In addition, the expensive conventional sludge drying methods are not effective enough for lipid recovery, thus reducing the potential biodiesel production. This study explores an alternative method, the direct sequential liquid-liquid extraction, which was performed in a batch mixer-settler reactor at room temperature, using hexane as a solvent, after previous sludge acidification showed significant increase in the lipid efficiency. The optimisation study demonstrated that, after three stages, 91% of lipid from primary sludge was recovered. The optimised extraction gave slightly higher lipid (27%, dry sludge) than the standard method (25%, dry sludge), supporting the suitability of the proposed process. Finally, this work demonstrates that the residual lipid-extracted sludge is still a good feedstock for energy production via anaerobic digestion. Anyway, the economic and environmental aspects of biodiesel production from sewage sludge could be improved. © 2014 Elsevier B.V.
    Àrees temàtiques: Química Materiais Interdisciplinar General chemical engineering Fuel technology Ensino Engineering, chemical Engenharias iv Engenharias iii Engenharias ii Engenharias i Energy engineering and power technology Energy & fuels Ciências ambientais Ciências agrárias i Ciência de alimentos Ciência da computação Chemistry, applied Chemical engineering (miscellaneous) Chemical engineering (all) Biotecnología Astronomia / física
    Accès a la llicència d'ús: https://creativecommons.org/licenses/by/3.0/es/
    ISSN: 03783820
    Adreça de correu electrònic de l'autor: agustin.fortuny@urv.cat frankerich.stuber@urv.cat christophe.bengoa@urv.cat afabrega@urv.cat jose.font@urv.cat a.fabregat@urv.cat
    Identificador de l'autor: 0000-0001-9424-1400 0000-0001-9160-5010 0000-0002-5525-5401 0000-0002-4007-7905 0000-0002-2878-1369
    Data d'alta del registre: 2024-09-28
    Versió de l'article dipositat: info:eu-repo/semantics/acceptedVersion
    Enllaç font original: https://www.sciencedirect.com/science/article/pii/S0378382014003324
    URL Document de llicència: https://repositori.urv.cat/ca/proteccio-de-dades/
    Referència a l'article segons font original: Fuel Processing Technology. 128 331-338
    Referència de l'ítem segons les normes APA: Olkiewicz M; Caporgno M; Fortuny A; Stüber F; Fabregat A; Font J; Bengoa C (2014). Direct liquid-liquid extraction of lipid from municipal sewage sludge for biodiesel production. Fuel Processing Technology, 128(), 331-338. DOI: 10.1016/j.fuproc.2014.07.041
    DOI de l'article: 10.1016/j.fuproc.2014.07.041
    Entitat: Universitat Rovira i Virgili
    Any de publicació de la revista: 2014
    Tipus de publicació: Journal Publications
  • Paraules clau:

    Chemical Engineering (Miscellaneous),Chemistry, Applied,Energy & Fuels,Energy Engineering and Power Technology,Engineering, Chemical,Fuel Technology
    Sewage sludge
    Liquid-liquid extraction
    Lipids
    Lipid
    Biodiesel
    Acidification
    Química
    Materiais
    Interdisciplinar
    General chemical engineering
    Fuel technology
    Ensino
    Engineering, chemical
    Engenharias iv
    Engenharias iii
    Engenharias ii
    Engenharias i
    Energy engineering and power technology
    Energy & fuels
    Ciências ambientais
    Ciências agrárias i
    Ciência de alimentos
    Ciência da computação
    Chemistry, applied
    Chemical engineering (miscellaneous)
    Chemical engineering (all)
    Biotecnología
    Astronomia / física
  • Documents:

  • Cerca a google

    Search to google scholar