Heat Transfer and Fluid Flow Characteristics in a Micro Heat Exchanger Employing Warm Nanofluids for Cooling of Electronic Components

Identifier:  imarina:9369691

Handle: https://hdl.handle.net/20.500.11797/imarina9369691

Authors:  Mokrane, M; Bourouis, M

Abstract:
The heat transfer enhancement and hydrodynamic characteristics of nanofluid use in a micro heat exchanger is investigated for cooling electronic components working in hot climatic conditions. The cooling fluid employed was water and TiO2 nanoparticles at mass concentrations of 1% and 5%, the Reynolds numbers ranged from 400 to 2000, and the inlet temperatures ranged between 35 degrees C and 65 degrees C. At a nanofluid inlet temperature of 55 degrees C and a nanoparticle concentration of 1%, the Nusselt number increased by 23% up to 54% as the Reynolds number varied between 400 and 2000. At a nanoparticle concentration of 5%, the percentages that correspondingly enhanced the Nusselt number were 32% and 63%. The temperature of the electronic heating component decreased by 4.6-5.2 degrees C when the nanofluid concentration was increased from 0 to 5% at a Reynolds number of 400 and a nanofluid inlet temperature of 35 degrees C. Small increments in the pressure drop of about 6% and 13% were observed at nanofluid concentrations of 1% and 5%, respectively. With nanoparticle concentrations of 1% and 5%, a Reynolds number of 2000, and a nanofluid inlet temperature of 35 degrees C, performance evaluation criterion (PEC) values of 1.36 and 1.45 were obtained. When the nanofluid inlet temperature increased to 65 degrees C, the PEC parameter decreased to 1.02-1.10 for both concentrations.